Types and debugging methods of chain link fence machines

13-04-2022


  Chain link fence machines are widely used in the manufacture of protective nets.


  Classification of Chain Link Fence Machines


  Chain link fence machine is a machine that can weave all kinds of metal wires into chain link fence. Our most common three kinds of chain link fencing machines are: automatic double wire diamond mesh machine, fully automatic single wire diamond mesh machine and semi-automatic diamond mesh machine.


  Automatic double-wire diamond mesh machine: It has the characteristics of: small footprint, double-wire feeding, automatic threading, automatic shearing, automatic mesh feeding, automatic edge locking, automatic folding and rolling of finished products, etc.


  Fully automatic monofilament diamond mesh machine: no need to consider the requirements of the wire, strictly control the speed of the mesh, etc., the operation is smooth, the production efficiency is high,


  Semi-automatic diamond mesh machine: The machine is automatically layered, automatically counted (meters and pieces), and automatically cut, but it needs to be manually woven into a mesh.


  Installation and debugging method of chain link fence machine


  Chain-link fencing machine is a kind of chain-link fencing machine that is made of wire. Chain-link fencing machine does not have high requirements for wire, and the thickness can be adjusted. The width of the wire mesh machine is adjustable. The mesh made has the characteristics of uniform mesh, flat mesh surface, beautiful appearance, not easy to corrode, long service life, simple weaving, beautiful and practical, etc. How to install and debug the chain link fence machine?

chain link fence machines

  The installation and debugging steps of the chain link fence machine are as follows:


  1. Open the cover before use and fill the gearbox with oil


  2. Add 10% soapy water or 1% emulsion to the sink


  3. Turn on the power supply (380V)


  4. Place the wire in the pay-off reel, and then thread the wire through it


  5. Insert the iron wire into the wire hole, and the iron wire passes through the middle of the pressure roller and enters the mold


  6. Place the mold on the platform and adjust the nut to keep the mold and the output shaft concentric


  7. Place the speed control handle at an appropriate speed (it is recommended that the new equipment run at low speed, and accelerate after running in for a certain period of time)


  8. Start the power supply


  9. The circulating water pump starts to work, and the lubricating fluid starts to circulate


  10. Lightly step on the clutch pedal and start working


  11. Hosts and platforms should be balanced


Get the latest price? We'll respond as soon as possible(within 12 hours)

Privacy policy